Please wait while the page loads...

2013 Toyota Camry Check Engine Light

A flashing light suggests that the problem is precarious and if not taken care of abruptly may result in humongous damage to the vehicle. If the check engine light in your 2013 Toyota Camry starts flashing, that means that the problem needs immediate attention and your Toyota should be brought in abruptly. This blinking light usually expresses a relentless engine misfire allowing unburned fuel to be deposited into the exhaust system. There it can shortly raise the temperature of the catalytic converter to a point where damage is likely, requiring an expensive repair. Some owners ask if spark plugs cause the check engine light to flash? This can strictly be the cause. A bad, long-established or dirty spark plug can cause the engine to misfire. If the problem is ignored or you continue to commute, this can spread to the spark plug wires, catalytic converter, or ignition coils which can lead to a exceptionally pricey repair. If your check engine light is flashing, please contact our department of automotive experts at Nalley Toyota of Roswell expeditiously by calling 7707637398.

Will the check engine light reset itself?

The check engine light on your 2013 Toyota Camry will usually shut itself off if the issue or code that caused it to turn on is fixed. For example, if the cause of your check engine light coming on was a loose gas cap, if it's tightened, the light will turn itself off. Likewise, if your catalytic converter is going prudent, and you did a lot of stop-and-go driving, that may have turned on the check engine light due to the high usage of the converter. In most cases, your 2013 Toyota Camry light will go off after about 20-40 miles. If you drive over that amount and the light is still on, you will need to bring it in to Nalley Toyota of Roswell so the light and code can be double-checked and reset.

Is it safe to drive your 2013 Toyota Camry with the check engine light on?

This question is not notably straightforward because it all depends on the severity of the issue. If the cause is a minor issue, such as a loose gas cap, it should be safe to drive. This is normally indicated by a steady glow of the check engine light. If you notice a difference in the performance of the vehicle, it could be an indication of a more scrupulous problem. If the check engine light is flashing, this means that there is a scrupulous issue and it is recommended to service your Toyota Camry suddenly. Call the experts at Nalley Toyota of Roswell by dialing 7707637398 so you can describe the issues. Or reduce your speed and bring your 2013 Toyota to our certified mechanics as soon as ready for use.

What could cause the check engine light to come on in a 2013 Toyota Camry?

When your check engine light comes on, this could be as authentic as tightening or replacing your gas cap. Likewise, the check engine light could also be a warning of a perilous problem that could cause perilous damage to your engine and come with a big repair bill. Depending on your make and model, the check engine light will illuminate or blink. A steady glow regularly means something less perilous but a flashing check engine light illustrates that your vehicle’s engine is in perilous trouble and service is necessary quickly. If your check engine light is flashing in your 2013 Toyota Camry, we immensely recommend not to drive the automobile and schedule Toyota service now. Below is a list of the most important reasons your check engine light can come on:

  • Your catalytic converter is bad or going bad. The catalytic converter is a part of your 2013 Toyota Camry’s exhaust system. The catalytic converter's work is to turn the carbon monoxide created by the combustion process into carbon dioxide. A damaged catalytic converter is usually caused by neglected maintenance, which is why Nalley Toyota of Roswell offers a complimentary multi-point inspection with every Toyota service. If you have an issue with your catalytic converter and don't get it repaired, your 2013 Toyota Camry will not pass an emissions test, show a lack of engine performance and will negatively affect your fuel economy. Your car may run at a higher temperature, too, which can cause other problems from overheating.
  • Issues with any aftermarket items. An aftermarket alarm, exhaust or other item can wreak havoc on your 2013 Toyota Camry if it’s not installed subsequently. These aftermarket elements and accessories can ditch the battery, trigger the check engine light, or even avert the vehicle from starting. If these issues sound ongoing, bring your Camry to Toyota and have our unit of certified mechanics ensure that your aftermarket items were installed correctly and aren't causing any issue. Getting accessories, chiefly aftermarket parts and accessories, or using OEM elements first place might cost a small bit more but could save you money from having to get poor work and break caused by poor installation work corrected.
  • The battery is low or dead. The battery in your 2013 Toyota Camry is every flashy. Without a car battery, your car won’t start, light up the road ahead, play the radio or charge your phone. Today’s car batteries last much longer than they did a lot decades ago, and they don't really require maintenance. The price of a new one depends on the type of Toyota you drive, but check our existing service coupons and specials.
  • Your 2013 Toyota Camry has a vacuum leak. Every Toyota Camry has a vacuum system that performs a expanded mixture of functions. The vacuum system also helps lower harmful emissions by routing the fumes as gasoline evaporates through the engine. If you notice that your RPM is high in idle or randomly surges, a vacuum leak could be the cause. Over time, vacuum hoses can dry out and crack, chiefly if they’re exposed to dramatic heat or extreme angry.
  • New Spark Plugs or Plug Wires are needed for your 2013 Toyota Camry. The spark plugs are the part of your engine that ignites the air/fuel mixture in the combustion chamber of your vehicle. This explosion is what moves the pistons and makes the engine run. The spark plug wires deliver the spark from the ignition coil to the spark plugs. If your spark plugs or spark plug wires are bad or classic, you will experience poor performance and reduced power. In a small extreme cases, your engine will have trouble starting or continuing to run. Worn spark plugs and plug wires can cause clogged catalytic converter or break to ignition coils and O2 sensors, dominant to more expensive repairs.
  • Your mass airflow sensor (known as MAF) needs to be replaced. The mass airflow sensor in your Toyota Camry is what determines how much fuel is needed to run your engine efficiently by measuring the amount of air entering the engine. As a part of the engine management system, the mass airflow sensor helps adjust to precise changes, like altitude. If your Toyota Camry is having trouble starting, idling rough or has a precipitous change in the position of the throttle pedal, this could be a sign of a bad mass airflow sensor.
  • Your O2 Sensor (Oxygen Sensor) needs to be replaced. The Oxygen sensor, common as the O2 sensor, measures the amount of oxygen in your exhaust system. If there is excess oxygen in your exhaust system, fuel burns faster and your vehicle will be less apt when it comes to fuel economy. So what happens if I don’t replace your O2 sensor? A faulty sensor can not only affect your miles per gallon, but it can cause break to your catalytic converter and your 2013 Toyota Camry's spark plugs. The O2 sensor sends data to the vehicle’s onboard computer to imply the noble mixture of air and fuel that enters the cylinders in your engine. A bad O2 sensor can also cause a car to fail an emissions test.
  • One of the most ongoing and countless cause is that your 2013 Toyota Camry gas cap is loose, damaged or missing. The gas cap for your 2013 Toyota Camry serves multiple purposes. It prevents gas fumes from being released when you aren't driving, it seals the fuel system and helps maintain pressure within the fuel tank. What happens if you have a bad fuel cap? If your gas cap is classic or has a ruptured seal, you can lose fuel through evaporation which will result in more trips to the pump. Luckily, to replace a gas cap isn't expensive. If your check engine light turns on urgently after you put gas in your 2013 Toyota Camry, first thing you should check is to make sure the cap isn’t loose — or that it's still on your car’s roof or at the fuel pump.

2013 Toyota Camry Check Engine Light Flashing

Although there are innumerable achievable causes of an illuminated Check Engine Light, we know from years of providing Check Engine Light Diagnosis Service that there are countless prevailing causes including something as effortless as a loose gas cap. Extra prevailing reasons for a Check Engine Light are a malfunction with the fuel injection system, damaged oxygen sensor, faulty head gasket, faulty emissions control part, dirty mass airflow sensor, or defective spark plugs to name various. No matter what is the root cause of the Check Engine Light, we have the Toyota Certified Technicians and the certified service protocol to isolate the root problem and repair it as decisive to restore factory specifications. When this happens, the Check Engine Light turns off, and you can leave the service center knowing that your Toyota issue was revamped.

Every 2013 Toyota Camry was designed with a high-technology performance monitoring system with a computer, and a series of sensors positioned strategically throughout the vehicle on its large systems. The sensors are continually detecting conditions while sending data to the electronic control department. If the electronic control department detects that the data is out of factory specifications, the Check Engine Light illuminates telling you that there is a problem. However, that is the limitation of the Check Engine Light – it won’t tell you what totally is untrue nor what to do about it. That’s where we come in; Nalley Toyota of Roswell provides a Check Engine Light Diagnosis Service that isolates the core problem and gives you a recommendation on what to do next from a Exceedingly Qualified Service skilled.

How much does it cost to get the engine light checked?

The average rate for a check engine light diagnosis & testing is typically between $88 and $111. The apt news, Nalley Toyota of Roswell offers complimentary multi-point inspections and free diagnostics, in most cases, to help determine the cause of your check engine light. The check engine light warns of issues ranging from a gas cap that's not accordingly tightened to a more alarming failure like a bad catalytic converter or a problem with one of the car's oxygen sensors, so it apt to get the real code reading and diagnosis.

How many miles can you drive with the check engine light?

The safest bet is to decipher the code and then plan your strategy accordingly. Since each check engine code has its own level of severity, it is difficult to predict how various miles you can drive with the warning light on. If you check engine light is flashing, we recommend that you pull over and contact Nalley Toyota of Roswell to help choose if your vehicle is safe to drive in or if we recommend a tow truck. It could be anything from a bad sensor to plug wires needing to be interchanged.

What Does the Check Engine Light Mean?

One of the most constantly misunderstood lights or indicators in your 2013 Toyota Camry is the check engine light. The check engine light is part of the onboard diagnostics system, and displays in a tiny alternative ways. It can say "Check Engine", it can be a symbol of an engine, it can even be a combination of both. This light flashes in either an amber or red color and is part of the diagnostics system found on your vehicle. Onboard computers increasingly have controlled and monitored vehicle performance since the 80s and do a assortment of things for your 2013 Toyota Camry. Some of these include controlling engine speed, ignition timing, shifting automatic transmissions and implementing stability control, just to name some. With that being said, the check engine light can mean a variety of further things. It can be as authentic as your gas cap being loose or as critical as engine knocking. If your check engine light is on in your 2013 Toyota Camry, contact Nalley Toyota of Roswell. Contact Nalley Toyota of Roswell today! Our Toyota service department can help you find out what code is turning your check engine light on or diagnose why your check engine light is flashing.

Check Engine Light Service 2013 Toyota Camry

What do you do when you’re driving along in your Toyota Camry and suddenly, a yellow light illuminates on your dash and says "Check Engine". If you’re like most Toyota owners, your heart sinks a miniature because you have miniature idea about what that light is trying to tell you or how you should react. The fear of the unknown (or the cost of the unknown) can be just as stressful. But take a deep breath and realize the light coming on doesn’t mean you have to pull the car over to the side of the road and call a tow truck, but it is recommended that you get your 2013 Toyota Camry checked as soon as ready for use. Ignoring that warning could end up causing major damage to expensive engine components.

When your 2013 Toyota Camry's ECM (electronic control module), which is the vehicle's onboard computer, finds a problem in the electronic control system that it can’t factual, a computer turns on your check engine light. This amber or yellow light is mostly labeled “check engine” or “service engine soon”, or the light may be nothing more than a picture of an engine, or a picture of the engine with the word “check.”

When the light turns on, the ECM stores an engine code or “trouble code” in its memory that identifies as the issue, whether it's a sensor or a failing engine part. This code is read with an electrical audit tool that is used by our Toyota auto repair mechanics at Nalley Toyota of Roswell. There are also a number of relatively bargain code readers that are designed for do-it-yourselfers, should you advantage that route too. While this code will tell you the issue that is detected, a true diagnosis still requires an professional persuasive to advantage the issue and repair it.

2013 Toyota Camry Check Engine Light Codes

The check engine light turning on can be quite intimidating to see that small light on your vehicle’s dashboard suddenly brightens, but in reality, it is not something that should cause you to shut down in fear good away. If you hear the term, diagnostic trouble codes (DTC), these are just distinct name for check engine light codes. These are automotive computer codes stored by the ECM, also known as the OBD (on-board computer diagnostic system) in your Camry. There are hundreds of discrete codes that your check engine light can represent. While that sounds daunting, with a small patience, tackling necessary diagnostics will give you beneficial knowledge about your vehicle and will also allow that Check Engine Light to do what it is really supposed to do: be your guide. Unfortunately, conspicuous and practical vehicle symptoms do not always accompany an illuminated Check Engine Light. Since there are hundreds of productive OBD codes, there are also hundreds of productive reasons for the light, including:

  • Computer output circuit issues
  • Fuel and air metering systems problems
  • O2 Sensor
  • Bad Spark Plugs
  • Transmission issues
  • Emissions controls issues
  • Ignition system faults
  • Loose Gas Cap or Missing Gas Cap
  • Old Battery

This is why it is imposing for someone who does not have a lot of automotive knowledge to not assume what a code means. If the engine light comes on due to a serious concern, you risk harmful your car further by not repairing the issue proper away. When your check engine light comes on, you should get it checked out suddenly by a certified Toyota mechanic. Call Nalley Toyota of Roswell at 7707637398 today or schedule your check engine light service online today!